332 DSView Installer/User Guide
Macros (Telnet/SSH applet)
about 204
creating 204
creating a macro group 206
deleting 206
deleting a macro group 208
editing 205
editing a macro group 207
enabling a macro group for use during a session
207
sending 206
Macros (Video Viewer)
about 178
adding/deleting macros in an existing macro
group 182
changing the group to be displayed 184
copying 181
copying a macro group 184
creating a macro group 181
creating and editing 179
deleting 180
deleting a macro group 183
displaying a macro group 185
renaming a macro group 183
sending 179
Managed appliances
adding a firmware file 261
adding a generic appliance 85
adding a single appliance 82
adding an appliance from a range of IP
addresses 84
adding an EVR1500 environmental monitor 85
changing an appliance name from the Unit
Overview window 88
changing local account settings 114
changing network properties 91
changing network settings 95
changing NTP settings (CCM appliances) 97
changing session settings 108
changing SNMP settings 98
changing unit access rights 94
changng NFS settings (CCM appliances) 96
configuring network settings 84
deleting firmware 262
displaying firmware information 262
displaying in Appliances window 75
displaying the Appliance Firmware Files
window 261
displaying user access rights 150
displaying version information 100
enabling/disabling secure mode 83, 84
events 266
rebooting 240
restoring a configuration 243
restoring a user database 244
resynchronizing 241
saving a configuration 242
saving a user database 243
updating the firmware of an appliance type
using the Add Task Wizard 258
upgrading firmware 240
See also SNMP
Migration
AVWorks software CCM appliances to
DSView software compatible units 254
DSView 2.x software units to DSView 3
software compatible units 253
Mouse settings
aligning in the Video Viewer 172
required before software installation 33
See also Video Viewer 33
N
NAT devices 30
Network settings for managed appliances 84
NFS settings and status (CCM appliances) 96
To Next Page
Loading...