2-35
Chapter 2 Installation of this Device
(iv) Selection of pipes
For connecting pipes from the process, select pipe schedule numbers and nominal thicknesses in
accordance with process side selection criteria (conditions such as process pressure). Diameter
1/2B, schedule number 80 steel pipes are one example of connecting pipes which are commonly
used.
(v) Required parts example
When doing the piping work, refer to the piping example diagrams, and have the following parts
onhand. Select the rating, material, etc., of each part based on process side selection standards.
• Three-Way Manifold Valve
• Pipes
• Master Valve
• Unions or Flanges
• T-Joints
• Drain Valve
• Gas Vent Plugs
• Seal Pot (only for sealed tank, wet leg)
To Next Page
Loading...