3-1
Chapter 3 Starting and Stopping this Device
Chapter 3 Starting and Stopping this Device
Caution
If the transmitter uses SFN communication while the process is in the automatic control
state, the output may fluctuate, and the device may enter a dangerous operating state.
Before performing this operation, be sure to switch the control loop of the process to
manual control.
In this chapter, the following items will be described.
• Connecting a Communicator (CommStaff, HART Communicator, etc.) to this Device
• Verifying Settings such as the Required Tag Number, the Output Format of this Device,
etc., during Receiving Inspection
• Preparations before Measurement
• Starting and Stopping Measurement
• Items Necessary when Stopping this Device for Maintenance and Replacement
For information regarding communicator usage, see the operation manual for the relevant device.
Field Communication Software CommStaff User's Manual: CM2-CFS100-2001
Field Communication Software CommStaff Instruction Manual: CM2-CFS100-2003
Advanced Transmitter (HART Version 5) Edition
Field Communication Software CommStaff Instruction Manual: CM2-CFS100-2013
Advanced Transmitter (HART Version 7) Edition
Supplement Manual for HART Communication Option: CM2-GTX000-2002
Advanced Transmitter (HART Version 5)
HART Communicator Operation Manual: CM2-GTX000-2003
Advanced Transmitter (HART Version 7)
Before connecting to this device, be sure to read the operation manual carefully.
To Next Page
Loading...