3-33
Chapter 3 Starting and Stopping this Device
(ii) Zero adjustment
Zero adjustment of this device can be performed by communicating with the device using
a communicator, or via external zero adjustment (optional function, see section 3-9).
(1) If the liquid level in the tank can be set to the minimum value (0%) of the measurement range
(1) Using a communicator
Section 3-7, “Zero adjustment based on actual level during liquid level measurement,”
Section 3-8, “Zero adjustment based on range-equivalent input pressure,” are the sections
to which to refer.
(2) Using external zero adjustment (optional function)
Section 3-9, “External zero adjustment (optional function),” is the section to which to refer.
(2) If the liquid level in the tank cannot be set to the minimum value (0%) of the measurement range
(1) Using a communicator
Section 3-7, “Zero adjustment based on actual level during liquid level measurement,”
is the section to which to refer.
(2) Using external zero adjustment (optional function)
Section 3-9, “External zero adjustment (optional function),”is the section to which to refer.
To Next Page
Loading...
Need help?
General
