Azbil MagneW Neo PLUS - 6-2-3: Setting Using SFC Communication (2) - Setting Using CONFIG Functions; Selecting Unit System and Setting Specific Gravity [UNIT KEY] Function

Operation using the data setting device Azbil Corporation
6-42 Model MTG11A/18A, MTG11B/18B, MTG14C
6-2-3: Setting using SFC communication (2) - setting using
CONFIG functions
Selecting unit system and setting specific gravity [UNIT KEY]
function
It is possible to select unit system (Mass flow rate and volume flow rate) which is set
by two wired magnetic flowmeter converter, and set the specific value (in case of
selecting mass flow rate for system units). Use the following procedure to select unit
system and to set specific gravity.
Step Key Procedure SFC screen
1 Confirm that the SFC is set to
“READY”.
If it is not, press the key to set it
to “READY”.
2
Press the key to access the
CONFIG functions. Confirm that the
screen on the right appears.
3
Press the key. The screen, which
system of units can be selected,
appears as shown to the right.
Mass flow rate = MASS FLOW
Volume flow rate = VOLUME FLOW
Press the key, and select MASS
FLOW or VOLUME FLOW.
4
Press the key. The screen as
shown on the right appears and the
changed setting is saved to the SFC.
5
or
Only when MASS FLOW is selected,
a screen for setting the specific gravity
appears. Press the key or
key to show this screen. Press numeric
keys to set specific gravity. Available
range of specific gravity is from
0.1000 to 5.9999.
CLR
( No )
CLR
( No )
SFCM00006009D
B
CONF
B
CONF
SFCM00006079D
SFCM00006080D
ENTER
( Yes )
NON-VOL
MENU
I
ITEM
DE CONF.
ENTER
( Yes )
NON-VOL
MENU
I
ITEM
DE CONF.
SFCM00006081D
ENTER
( Yes )
NON-VOL
ENTER
( Yes )
NON-VOL
SFCM00006082D
H
NEXT
L
PREV
H
NEXT
L
PREV
SFCM00006083D
CM2-MTG300-2001.book 42 ページ ２０１５年９月２９日 火曜日 午前１０時１４分