Azbil Corporation Operation using the data setting device
Model MTG11A/18A, MTG11B/18B, MTG14C 5-41
5-6-1 : Setting ID
You can enter a unique 8-digit alphanumeric code for the flowmeter.
Up to eight alphanumeric characters using any combination of letters (A to Z),
numbers (0 to 9), - (dash), / (slash), space and period.
Set an ID in accordance with the following procedure:
Step Procedure Screen
1 Enter ENGINEERING MODE (see section 5-5-
10 : on page 5-36) and display the screen where
the ID is to be set.
2 Press the key to move the cursor to the position
under a desired character to be changed.
3 Press the or key to select a desired character.
4 If a target TAG NO. has been set, press the key
to move the cursor to the position under #.
Press the MODE key to return to MEASURING
MODE and to save data.
12.3 %
# ID SET
XXXXXXXX
12.3 %
# ID SET
XXXXXXXX
12.3 %
# ID SET
FXXXXXXX
12.3 %
# ID SET
FIC-0001
CM2-MTG300-2001.book 41 ページ ２０１５年９月２９日 火曜日 午前１０時１４分
To Next Page
Loading...
