Azbil MagneW Neo PLUS - Printing Internal Data: PRINT Key

Azbil Corporation Operation using the data setting device
Model MTG11A/18A, MTG11B/18B, MTG14C 6-37
Printing internal data: PRINT key
Used when
Configuration printout (data printout) is used to print out internal data of the converter
such as a damping time constant, low flow cutoff, etc.
Procedure
Use the following procedure to carry out configuration printout.
Step Key Procedure SFC screen
1 Start communication between the
SFC and converter. For a detailed
procedure, see “Starting
communication: ID/DE READ key”
on page 6-19.
2 Make sure that the SFC is set to
“READY”.
If it is not, press the key set it to
“READY”
3
Press the key.
4
Press the key.
Result:
• Configuration printout starts.
5 When printing is completed, press the
key to return step 2.
CLR
( No )
CLR
( No )
SFCM00006009D
SHIFT
SHIFT
SFCM00006002D
P
9
PRINT
P
9
PRINT
SFCM00006015D
SFCM00006016D
CLR
( No )
CLR
( No )
CM2-MTG300-2001.book 37 ページ ２０１５年９月２９日 火曜日 午前１０時１４分