Azbil MagneW Neo PLUS - Installation Method; Installing a Wafer Type Detector; Basic Installation; Figure 2-9 Device Installation Example

Azbil Corporation Instrument installation
Model MTG11A/18A, MTG11B/18B, MTG14C 2-11
2-2 : Installation method
2-2-1 : Installing a wafer type detector
Basic installation
Introduction
Process connection of the instrument are wafer type, flange type, union, hose, or
clamp unit. Referring to the appropriate method of installation, install the unit
properly.
Installation example
Figure 2-9 shows the basic method for installing the device.
Fastening torque
Figure 2-9 Device installation example
m CAUTION
Be careful in handling this unit. It is heavy, dropping it accidentally could cause
injury.
m CAUTION
Table 2-1 shows the fastening torque for each pipe bore. Using centering hardware,
apply the prescribed fastening torque to prevent any liquid leak from the pipe.
Nuts (optional)
Pipe
Gasket (Provided by customer
in case of SUS material
grounding rings.
In other cases, a gasket is
supplied.)
Through-bolts (optional)
Centering nuts
(accessory)
CM2-MTG300-2001.book 11 ページ ２０１５年９月２９日 火曜日 午前１０時１４分