Operation using the data setting device Azbil Corporation
6-74 Model MTG11A/18A, MTG11B/18B, MTG14C
Setting pulse scale and pulse scale unit [PULSE CONFIGURE]
function
Use the following procedure to set the pulse scale and the pulse scale unit using SFC.
However, set the span frequency range: 0.001 Hz to 200 Hz. (Span frequency is a
pulse frequency when the maximum range (100%) of flow rate flows.)
Step
Key Procedure SFC screen
1 Confirm that the SFC is set to
“READY”.
If it is not, press the key to
set it to “READY”.
2
or
Press the key to access the
CONFIG functions. Press the
key or key to display the
screen as shown on the right
3
or
Press the key to access the
TOTALIZER functions. Press the
key or key to display
the screen as shown on the right
4
or
Press the key to enter into
PULSE setting function and press
the key or key to
display the screen as shown on the
right.
Displays the actual pulse scale unit.
5
Press the key and select the
unit to be set. Available units are in
the actual unit system.
CM2-MTG300-2001.book 74 ページ ２０１５年９月２９日 火曜日 午前１０時１４分
To Next Page
Loading...
