Model MTG11A/18A/11B/18B/14C System configuration and structure Azbil Corporation
1-10 Model MTG11A/18A, MTG11B/18B, MTG14C
Names and description of various parts
The following table gives a description of the various parts.
Figure 1-6-2 Overview of remote type
Name Description
Detector • When a fluid passes through the inside, the detector
generates a signal of electromotive force that is
proportional to the flow rate of the passing fluid.
• Connects to the pipes and supports the entire instrument.
• Hoses the electrodes, both electrodes are installed in a
horizontal position.
Converter • Converts the signal of electromotive force generated by the
detector into an instantaneous flow rate value and outputs it
as a flow rate signal.
Special cable • It transmits the electromotive force and the excitation
current generated by the detector.
• The shielded special cable offers strong protection against
electromagnetic interferences and environment influences.
Display panel • It displays the instantaneous flow rate value and the
internal state of this flowmeter.
Terminal box • Contains output signal and grounding terminals.
Nameplate • MODEL No., PRODUCT No. and detector constant (EX)
are written.
TAG No. plate • TAG No. is written according to the order specification.
Converter
Display /
Data setting unit
Terminal box
Special cable
Terminal box
Detector
Tag no. plate
Nameplate
CM2-MTG300-2001.book 10 ページ ２０１５年９月２９日 火曜日 午前１０時１４分
To Next Page
Loading...
