Azbil MagneW Neo PLUS - Entering TAG No.: ID Key

Azbil Corporation Operation using the data setting device
Model MTG11A/18A, MTG11B/18B, MTG14C 6-21
Entering TAG No.: ID key
Introduction
To facilitate concentrated control by the control system of the control loop over two or
more converters, a TAG No. can be assigned to each converter. Up to 8 alphanumeric
characters can be entered as a TAG No.
Procedure
Use the following procedure to enter TAG No.
Step Key Procedure SFC screen
1 Check that the display of the SFC
appears as shown to the right.
If a different display appears, refer to
“Setting using SFC communication (1)
- setting using key assigned functions”
on page 6-19.
2
+
Carry out the following operation
according to the output format of the
SFC used.
• For SFN.A analog output
communication method, press the
key.
• For SFN.D digital output
communication method, press the
+ keys.
(For SFN.A)
(For SFN.D)
3
-Use the key and numeric keys to
enter up to 8 alphanumeric characters
for a TAG No.
~Note
• On this screen, the key and
numeric keys and key and
key are active. Even if other
keys are pressed, there will be no
response.
• To enter letters, press the key
and display the ““cursor.
• To en ter numerals, press the
key again and display “_” cursor.
SFCM00006005D
A
ID
DE READ
SHIFT
A
ID
DE READ
A
ID
DE READ
SHIFT
A
ID
DE READ
SFCM00006007D
ALPHA
Q
ADE
M
ALPHA
ALPHA
ALPHA
ALPHA
Q
ADE
M
ALPHA
ALPHA
SFCM00006030D
CM2-MTG300-2001.book 21 ページ ２０１５年９月２９日 火曜日 午前１０時１４分