Azbil Corporation Operation using HART communicator
Model MTG11A/18A, MTG11B/18B, MTG14C 7-31
5. Figure 7-59 will then appear. When
executing the adjustment, press F4
(ENTER) to start the adjustment.
Figure 7-59
6. Figure 7-60 will then appear. Please
wait until the adjustment completes.
Figure 7-60
7. After the gain adjustment has been
completed, display shown in Figure 7-
61 appears. Gain adjustment of 0.0 m/
s is now completed. For gain
adjustment of 2.5 m/s and 10 m/s,
follow the same procedures as shown
in above.
Figure 7-61
CM2-MTG300-2001.book 31 ページ ２０１５年９月２９日 火曜日 午前１０時１４分
To Next Page
Loading...
