IS-28/28s
Baader Ísland ehf, Hafnarbraut 25, Kopavogur, IcelandTel: +354 520 6900 Fax: +354 520 6911
lager@baader.is / www.baader.is
7
SAFETY MEASURES
The machine operators, repair technicians or cleaning personnel must read,
understand and observe the manual when performing all the necessary actions.
Safety instructions
- Misusage and wrong operation of the machine can cause serious health
and physical damage.
- It is forbidden to short-circuit, change or remove safety equipment from the
manufacturer.
- Security marking on the machine must be always noticeable and legible.
Faulty or worn-out safety marking must be immediately replaced.
- Read the manual before operating the machine.
- It is forbidden for untrained personnel to deploy and operate the machine.
- Wear tight body workwear, especially covering the arms.
- Tie long hair together and cover it.
- Do not wear watches, rings, bracelets, etc.
- Do not interfere with the machine while it is running.
- Do to place any objects on the machine.
- Do not step on or use conveyor belts for storage of heavy objects.
- Bacterial infections in cut injuries can cause complications (e.g. blood
poisoning). It is impossible to eliminate these consequences even if the
machines are thoroughly cleaned and disinfected! Therefore observe the
following:
o Clean the machine thoroughly and disinfect it before the installation,
the end of operation, maintenance and repair.
o Wear protective gloves while working on machine parts or tools with
sharp edges.
o Never run a check on the bit of the cutting edge on the skin.
o Seek medical assistance immediately in case of cut injuries!
- It is forbidden to spray any substance into the electrical switch box and the
switching device; fire and explosion risk!
- Do not let the machine run unattended.
- Turn the machine off, put the main switch in 0-position and lock it:
o in case of disruptions in the processing flow
o before cleaning
o before the installation and end of operation
o before maintenance and repair work
o before lubrication
o before leaving the machine area
- Maintenance and repair work may only be performed when the machine is
at rest. Make sure it is impossible to turn the machine on and an
appropriate warning sign is in place.
- To make sure it is impossible to turn the machine on, the main switch must
be padlocked.
To Next Page
Loading...