IS-28/28s
Baader Ísland ehf, Hafnarbraut 25, Kopavogur, IcelandTel: +354 520 6900 Fax: +354 520 6911
lager@baader.is / www.baader.is
48
CONTROL PANEL
The control equipment of the machine is divided into 4 parts:
- The switch box where the machine is started, stopped and speed of the
drawers controlled
- The air board where air pressure on the jack is controlled
- The water board where water volume in every place is controlled
- And the main switch box where the machine is turned on
Switch box old
Figure 44
1.
a) Light. When the light is on, the machine is on and the safety system is closed.
This means that all the protective parts are closed, the phases in the motors
are correct and the main switch is in the I-position.
b) The restart button for the safety switch, when pressed for 3 seconds, is used
only if the safety switch is connected incorrectly.
2. Speed adjustment. It controls the speed of drawers.
3. The Start button. It starts the machine when pressed on it.
4. The Stop button. It stops the machine.
It is also possible to activate the Stop button by pressing on the cover of the
protective part above the switch box.
To Next Page
Loading...