Banner Q4X User Manual

8.2 Brackets
All measurements are listed in millimeters, unless noted
otherwise.
SMBQ4X..
•
Swivel bracket with tilt and
pan movement for
precision adjustment
• Easy sensor mounting to
extruded rail T-slots
• Metric and inch size bolts
available
• Side mounting of some
sensors with the 3 mm
screws included with the
sensor
40
43
A
B
B = 7 × M3 × 0.5
Model Bolt Thread (A)
SMBQ4XFA 3/8 - 16 × 2¼ in
SMBQ4XFAM10 M10 - 1.5 × 50
SMBQ4XFAM12 n/a; no bolt included. Mounts
directly to 12 mm (½ in) rods
SMB18FA..
•
Swivel bracket with tilt and
pan movement for precision
adjustment
• Easy sensor mounting to
extruded rail T-slots
• Metric and inch size bolts
available
• 18 mm sensor mounting hole
66
69
A
B
Hole size: B=ø 18.1
Model Bolt Thread (A)
SMB18FA 3/8 - 16 × 2 in
SMB18FAM10 M10 - 1.5 × 50
SMB18FAM12 n/a; no bolt included. Mounts
directly to 12 mm (½ in) rods
SMB18A
•
Right-angle mounting
bracket with a curved slot
for versatile orientation
• 12-ga. stainless steel
• 18 mm sensor mounting
hole
• Clearance for M4 (#8)
hardware
30
41
46
A
B
C
Hole center spacing: A to B = 24.2
Hole size: A = ø 4.6, B = 17.0 × 4.6, C = ø 18.5
SMBAMS18P
•
Flat SMBAMS series
bracket with 18 mm hole
• Articulation slots for 90+°
rotation
• 12-ga. (2.6 mm) cold-
rolled steel
45
78
A
B
C
Hole center spacing: A = 26.0, A to B = 13.0
Hole size: A = 26.8 × 7.0, B = ø 6.5, C = ø 19.0
SMBAMS18RA
•
Right-angle SMBAMS
series bracket with 18 mm
hole
• Articulation slots for 90+°
rotation
• 12-ga. (2.6 mm) cold-
rolled steel
48
45
40
A
B
C
Hole center spacing: A = 26.0, A to B = 13.0
Hole size: A = 26.8 × 7.0, B = ø 6.5, C = ø 19.0
Q4X Stainless Steel Laser Sensor with Dual Discrete Outputs and IO-Link
www.bannerengineering.com - Tel: 763.544.3164 43

Banner Q4X Specifications

General

Sensing Mode	Diffuse
Input Voltage	10 V DC to 30 V DC
Output	NPN or PNP
Housing Material	Stainless steel
IP Rating	IP67
Connection Type	M12