Banner Q4X User Manual

Method Action Result
Push Button
Press TEACH to teach the target. The sensor begins sampling target
distance information and
and
flash alternately on the display.
The DYN indicator flashes.
Remote Input
Single-pulse the remote input.
T
4. Present the targets.
Method Action Result
Push Button
Present additional targets. The sensor-to-target distance must be within
the sensor's range.
The sensor continues to sample target
distance information and and
flash alternately on the display.
The DYN indicator flashes.
Remote Input
5. Teach the sensor.
Method Action Result
Push Button
Press TEACH to stop teaching the sensor.
The new switch point flashes rapidly
and the sensor returns to Run mode.
Remote Input
Single-pulse the remote input.
T
Table 4: Expected TEACH Behavior for Dynamic Background Suppression
See Figure 23 on page 34 for the minimum object separation.
Condition TEACH Result Display
Two valid distances that are greater
than or equal to the horizontal
minimum object separation
Sets a switch point between the two taught
distances.
The switch point distance flashes on
the display.
Two valid distances that are less than
the horizontal minimum object
separation
Sets a switch point in front of the furthest taught
distance by the horizontal minimum object
separation.
and the switch point distance
flash
alternately on the display.
One valid distance with one invalid
TEACH point
Sets a switch point between the one taught
distance and the maximum range.
and the switch point distance
flash
alternately on the display.
Two invalid TEACH points
Sets a switch point at the following location:
Model Switch Point
100 mm threaded barrel models 75
300 mm threaded barrel models 200
600 mm threaded barrel models 400
110 mm flush mount models 85
310 mm flush mount models 210
610 mm flush mount models 410
and the switch point distance
flash
alternately on the display.
3.6.3 One-Point Window (Foreground Suppression)
One-point window sets a window (two switch points) centered around the taught target distance. Loss of signal is treated as a
detection in One-Point Window mode. The size of the taught window is the vertical minimum object separation. See Figure 23 on
page 34.
Manually adjust the window size from Run mode using
and .
Q4X Stainless Steel Laser Sensor with Dual Discrete Outputs and IO-Link
22 www.bannerengineering.com - Tel: 763.544.3164

Banner Q4X Specifications

General

Sensing Mode	Diffuse
Input Voltage	10 V DC to 30 V DC
Output	NPN or PNP
Housing Material	Stainless steel
IP Rating	IP67
Connection Type	M12