9. Software updating
Image 9-7
Press the Standby button at the front if the unit does not start up automatically.
5. On the keyboard, press F12.
Press F12 immediately after starting up the Base Unit and keep it pressed until a message appears on screen asking to enter a
password.
Image 9-8
6. Enter ’clickshare’ as password.
Beware when entering the password as the Base Unit will assume a QWERTY keyboard.
The following screen appears.
Image 9-9
Note: The brand of the software recovery stick may vary.
7. Select the software recovery stick and press Enter.
R5900006 CLICKSHARE 04/12/2013
89
To Next Page
Loading...
