Barco CLM W6 - Chapter 2 Disassembly Process; Equipment Needed & Product Overview

2-1
CLM W6_CLM HD6 Jan 31, 2012
Chapter 2 Disassembly Process
2. Disassembly Process
2-1 Equipment Needed & Product Overview
1. Screw Bit (+) :105
2. Screw Bit (+) :107
3. Screw Bit (-) :107
4. Hex Sleeves 5 mm
5. Tweezers
6. + NO.0 Screwdriver
7. Knife
8. Projector
* Caution:
-This process is protective level II. Operators should wear electrostatic chains.
-The unit should be powered down and disconnected from mains.
 -WhendisassembleEnginemodule(2-18),pleasenoticethatitrequirespecic  
environmental conditions (clean room).