5-2
CLM W6_CLM HD6 Jan 31, 2012
Chapter 5 Firmware Upgrade
5-1-2 Firmware Upgrade
Procedure
1. Setup
- Plug in the power cord.
- Connect projector and PC by RS232
cable.
- Turn on the power switch, let projector in
standby mode
Note: - The lamp will not operate.
2. Please download the latest FW program le
from website, unzip the le and keep on your
desktop, then double click the folder.
3. Execute the BarcoUI.exe
4. Set the COM port which you are using.
RS232 Port
Power Port
Power Switch
To Next Page
Loading...
Need help?
General
