5. Getting started
5.4.4 Going from ON to READY
Description
Press and hold the Power on/off button on the p rojector for 3 s econds, or press the Power O ff b utton on the remote control. The
projector will power down through a cool down phase. The Power on/off button will BLINK WHITE during the transition from ON to
READY. Once the projector is in RE ADY,thePowe r on/off butto n will be lit WHITE.
5.4.5 Going from READY to ECO standby
Description
If ECO Standby mode is enabled in the service menu (refer to the section "GUI - system settings/Standby ECO ", in User Guide) the
projector will automatically go to ECO standby mode after a time-out (default 15 minutes). A ll elect
ronics (including fans, pumps,...)
go down except for a very small wake up controller. The Power on/off button will FLAS H WHITE every second.
5.4.6 Going from ECO to ON
Description
Press the Power on/off button on the projector, or the Power O n button on the remote control. The projector goes from ECO directly
to ON. The projector w ill g o through the same booting phase as on powe r plugging, then do the transition from READY to ON .Of
course startup-time will be longe r then from RE ADY to ON.
5.5 Power modes
General
The table below details the F70 power modes.
Mode Description
Normal Projector is b ooted up a nd the light source is on
Ready
Projector is booted up but the light sour ce is off
ECO Standby Light source is s witched o ff and projector electronics are
powered down
5.6 Customize projector settings
About
The pro jector display, behavior a nd user interface can be adjusted to meet individual requirements.
Options include:Home/System Settings/Themes
• Adjust the OSD menu color
5.7 User interface
Overview
• On S creen Display (OS D)
5.7.1 On Screen Display (OSD)
About
The pro jector on screen display (OSD ) is the primary u ser interface (UI). F rom here, y ou can review and adjust all projector and
display settings.
The OSD interface uses tabs to display the main menu. Topics are then further sorted and displayed by function: main (topic) —
sub (function) — sub (function).
There are six m ain menu tabs: Source, Image, Installation, System settings, Test pattern and Status.
The OSD can be disabled by pressing t
he OSD on/off button.
46
601–426 F70 SERIES 24/10/2017
To Next Page
Loading...
Need help?
General
