Basler A102f - Page 88

Configuring the Camera
4-26 BASLER A102
f
DRAFT
Field Bit Description
Trigger 12 Indicates a trigger mode control error on the A102f or A102fc.
0 = no error present
1 = A setting in the trigger mode control register (see page 4-24) is
outside of the allowed range
This field is read only.
Trigger Delay
13 Not used on the A102f or A102fc. This bit should be ignored.
White Shading 14 Not used on the A102f or A102fc. This bit should be ignored.
Frame Rate 15 Not used on the A102f or A102fc. This bit should be ignored.
--- 16 ... 31 Reserved
Register Name: Feature Control Error Status Low
Offset from Base Address: 0x644
Field Bit Description
Zoom 0 Not used on the A102f or A102fc. This bit should be ignored.
Pan 1 Not used on the A102f or A102fc. This bit should be ignored.
Tilt 2 Not used on the A102f or A102fc. This bit should be ignored.
Optical Filter 3 Not used on the A102f or A102fc. This bit should be ignored.
--- 4 ... 15 Reserved
Capture Size 16 Not used on the A102f or A102fc. This bit should be ignored.
Capture Quality 17 Not used on the A102f or A102fc. This bit should be ignored.
--- 18 ... 31 Reserved