Revision History
BASLER A102
f i
DRAFT
Revision History
Doc. ID Number Date Changes
DA00063001
24 October 2003 Initial release of this document.
DA00063002
25 February 2004 Second draft for revision two of the manual.
Added Section 1.1 describing document applicability.
Updated Sections 2.5, 3.2.5, 3.3, and 3.4 to reflect the new in-
put and output port configuration options.
Added Section 3.2.4 describing the new software trigger fea-
ture.
Updated the numbers in Figure 3-6 to reflect minor changes in
the exposure timing.
Updated the note box on page 3-20 to show restrictions when
setting the AOI on color cameras.
Added Section 3.6.1 describing changing the AOI on-the-fly.
Updated the description of the color filter ID in Section 3.8.2.
Added Section 3.9.2 regarding bit depth selection on color cam-
eras.
Added Sections 3.10 and 3.11 describing the new Strobe Con-
trol Output Signal and Parallel IO Control features.
Added the Raw 16 color ID description on page 3-36.
Updated the register descriptions in Section 4.4 to reflect new
and revised features.
Added Section 6 describing the new smart features capabilities.
Revised Figure 7-1 to reflect a minor dimension change.
DA00063003
22 March 2004
Corrected errors in the description of the Control and Status Registers
for PIO Control on page 4-41.
Corrected errors in the description of the Control and Status Registers
for the Output Port Configuration smart feature on page 6-31.
DA00063004 31 August 2004
Added a note in Section 3.2.1 indicating that 38 µs is no longer added
to the exposure time.
Made changes to the formula in Section 3.7 to reflect some small tim-
ing changes that were made to the camera.
Updated Section 3.8.1 to describe the new method that is used for
white balancing.
Added a description of the new error flags in Section 3.14.
Added register descriptions in Section 4.4.2 for the new error flags.
Updated the drawings in Section 7.2.
Added mechanical stress test results in Section 7.4.
To Next Page
Loading...
Need help?
General
