Specifications, Requirements, and Precautions AW00123402000
30 Basler ace USB 3.0
1.8 Environmental Requirements
1.8.1 Temperature and Humidity
Housing temperature during operation: 0 °C ... +50 °C (+32 °F ... +122 °F)
(acA2000-165 and acA2040-90 only): 0 °C ... +60 °C (+32 °F ... +140 °F)
Humidity during operation: 20 % ... 80 %, relative, non-condensing
Storage temperature: -20 °C ... +80 °C (-4 °F ... +176 °F)
Storage humidity: 20 % ... 80 %, relative, non-condensing
1.8.2 Heat Dissipation
You must provide sufficient heat dissipation to maintain the temperature of the camera housing at
50 °C or less. Since each installation is unique, Basler does not supply a strictly required technique
for proper heat dissipation. Instead, we provide the following general guidelines:
In all cases, you should monitor the temperature of the camera housing and make sure that the
temperature does not exceed 50 °C (60 °C for acA2000-165 and acA2040-90 cameras). Keep
in mind that the camera will gradually become warmer during the first hour of operation. After
one hour, the housing temperature should stabilize and no longer increase.
If your camera is mounted on a substantial thermally conductive component (made of metal or,
preferably, thermally conductive polymers or ceramics) in your system, this may provide
sufficient heat dissipation.
The use of a fan to provide air flow over the camera is an extremely efficient method of heat
dissipation. The use of a fan provides the best heat dissipation.
To Next Page
Loading...
Need help?
General
