Basler Camera User Manual

Physical Interface AW00123402000
78 Basler ace USB 3.0
5.12.6.2 Setting the Timer Delay Time
You can set the Timer 1 delay by setting the Timer Delay parameter. The units for setting this
parameter are µs and the value can be set in increments of 1 µs.
1. Use the Timer Selector to select Timer 1.
2. Set the value of the Timer Delay parameter.
You can set the Timer Selector and the Timer Delay parameter value from within your application
software by using the Basler pylon API. The following code snippet illustrates using the API to set
the selector and the parameter value:
camera.TimerSelector.SetValue(TimerSelector_Timer1);
camera.TimerDelay.SetValue(100.0);
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the pylon API and the pylon Viewer, see Section 3.1 on page 37.
5.12.6.3 Setting the Timer Duration Time
You can set the Timer 1 duration by setting the Timer Duration parameter. The units for setting this
parameter are µs and the value can be set in increments of 1 µs.
1. Use the Timer Selector to select Timer 1.
2. Set the value of the Timer Duration parameter.
You can set the Timer Selector and the Timer Duration parameter value from within your application
software by using the Basler pylon API. The following code snippet illustrates using the API to set
the selector and the parameter value:
camera.TimerSelector.SetValue(TimerSelector_Timer1);
camera.TimerDuration.SetValue(10.0);
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the pylon API and the pylon Viewer, see Section 3.1 on page 37.
To set the delay for Timer 1:
To set the duration for Timer 1:

Basler Camera Specifications

General

Category	Security Camera
Brand	Basler
Resolution	Varies by model
Sensor Type	CMOS
Frame Rate	Varies by model
Dimensions	Varies by model
Weight	Varies by model
Interface	GigE, USB 3.0
Lens Mount	C-Mount, CS-Mount