Basler Camera User Manual

Physical Interface AW00123402000
68 Basler ace USB 3.0
5.11.3 Input Line Inverter
You can set input line Line 1 and GPIO lines Line 3 and Line 4 if configured for input, or not to invert
the incoming electrical signal.
1. Use the Line Selector to select, for example, Line 1.
2. Set the value of the Line Inverter parameter to true to enable inversion on the selected line or
to false to disable inversion.
You can set the Line Selector and the Line Inverter parameter value from within your application
software by using the pylon API. The following code snippet illustrates using the API to set the
selector and the parameter value:
// Select the input line
camera.LineSelector.SetValue(LineSelector_Line1);
// Enable the line inverter on the selected line
camera.LineInverter.SetValue(true);
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the pylon API and the pylon Viewer, see Section 3.1 on page 37
To set the invert function for an input line:

Basler Camera Specifications

General

Category	Security Camera
Brand	Basler
Resolution	Varies by model
Sensor Type	CMOS
Frame Rate	Varies by model
Dimensions	Varies by model
Weight	Varies by model
Interface	GigE, USB 3.0
Lens Mount	C-Mount, CS-Mount