INTRODUCTION
This instruction manual provides information about the operation and installation of the DGC-500 Digital
Genset Controller. To accomplish this, the following information is provided:
• General Information and Specifications
• Controls and Indicators
• Functional Description
• Communication Software Description
• Installation
• Maintenance and Troubleshooting
WARNING!
To avoid personal injury or equipment damage, only qualified personnel should
perform the procedures in this manual.
NOTE
Be sure that the DGC-500 is hard-wired to earth ground with no smaller than 12
AWG copper wire attached to the ground terminal on the rear of the unit case.
When the DGC-500 is configured in a system with other devices, it is
recommended to use a separate lead to the ground bus from each unit.
9355400990 Rev H DGC-500 Introduction i
To Next Page
Loading...
