Manual
C, 09/03
• Added descriptions associated with new settings: CANBus Address,
Engine Stop/Start Configuration, and Genset’s kW Rating.
• Added information pertaining to DGC Isolator Kits.
• Added Volvo Penta EDC application information and diagrams.
• Updated Pre-Alarm and Alarm information in Section 3, Functional
Description to include metric equivalents for settings.
B, 03/03
• Revised style chart to show NFPA compliance as standard, J1939
support as optional.
• Added coverage for part numbers 9355400111, 112, 113, and 114.
• Added information about J1939 interface, ECU support, and state
machine operation where appropriate.
• Revised BESTCOMS section to accommodate new ECU settings.
• Created new appendix of settings list with range for each setting.
A, 07/02
• Added instructions to Section 3, Functional Description for viewing
firmware version.
• Revised the maximum setting of Sender Failure Alarm Time from 10
seconds to 30 seconds in Tables 3-1 and 3-2.
• Replaced actual BESTCOMS version number in Figure 4-2 with
generic version number.
—, 02/02
• Initial release
9355400990 Rev H DGC-500 Introduction v
To Next Page
Loading...
