Baumer IDC200 - Header

8 | Web interface Baumer
40 Operating Manual IDC200 | V1.0
8.2.1 Header
The header is found in the top section of the user interface. The header is always visible, no
matter which mode is currently applied.
Sensor name
n
Sensor name
Expert Mode
n
Expert mode enable/disable.
n
In expert mode, more complex functions and parameters be-
come visible that require a deeper understanding of measure-
ment physics and the applied algorithm. The expert mode can
be activated and deactivated at any time.
n
Call up the context help.
Job (1 - 32)
n
Select desired job (1 - 32)
n
Change is adopted immediately. However, changes must be
saved in a job so that they are available after sensor restart.
Unsaved Jobs
n
Message that a change has not been stored yet.
n
Display sensor type
n
Display serial number.
n
Download diagnostic data from the device for submission to
helpdesk for further analysis.
n
Button for requesting support via e-mail.
n
Link to website.
EN
n
Selection of the language of the user interface.