8 | Web interface Baumer
46 Operating Manual IDC200 | V1.0
Auto Setup
INFO
Executing Auto Setup will delete all configured tools. If required, save a Job prior to execution.
Camera Picture
n
Exposure: automatic exposure settings
n
Focus: automatic focus settings
n
Object speed: Setting the objects' moving speed (e.g. on a conveyor
belt). It is automatically ensured that Exposure Time is small enough
to allow speed. For this reason,Gain may be increased to reduce Ex-
posure Time. Recommended to always specify a value for object
speed.
NOTE: Brightness is reduced by a polarizing filter, in an analog way
no polarizing filter will increase brightness. This will shorten expo-
sure time and increase object speed.
Code search
n
1D Barcode
n
2D Matrixcode
n
Search 2D Codes with separate tools (faster)
NOTE: Defining an evaluation range may be useful if the image has
more codes than must be read. This can be done by parameterization
of the corresponding measuring tool.
Tool add
+Tool Add Tools / Auxiliary tool
To Next Page
Loading...
