3 Disassembly / Assembly
Infusomat® compact
plus
P 1.0 3 - 3
EN
For internal use, only
REMARKS ON ASSEMBLY General
The modules and subassemblies are installed or assembled in
reverse order of removal or disassembly. Work steps that require
special attention are given in the sections following the disas
-
sembly instructions of each part. Therefore read the assembly
instructions in reverse order starting with the part disassembled at
last. Prerequisites that must be met are given at the beginning of
each section.
The Infusomat® compact
plus
P is ingress-protected according to
IP34 classification. Therefore, following the instructions about
thread locking and greasing is obligatory.
Always use new cover caps only.
Special screws
The special screws for plastic housings are not self-cutting but
form a thread in the plastic of the housing by deformation when
first inserted.
When inserted subsequently, the screw will produce a new thread
if it does not coincide with the exact start of the existing thread.
This destroys the old thread. The screw fastening will then not be
secure.
Proceed as follows to fit the special screws for plastic housings:
1. Position the special screw for plastic housings on the thread.
2. Turn the screw counterclockwise (unscrew) until a faint click
can be heard. This click is produced when the screw thread
drops into the thread of the housing.
3. Screw in the screw and tighten with the specified torque.
NOTICE
Special screws for plastic housings are used in this device. These
are screws specially designed for plastic housings. Pay attention
to the relevant notes when you fit the screws.
To Next Page
Loading...