Menu
54
NGRM7xx_D00292_07_M_XXEN/02.2022
IP (menu 7.3.2.2)
Set the appropriate IP address for the NGRM7…
SN (menu 7.3.2.3)
Set the appropriate subnet mask.
Std. GW (menu 7.3.2.4)
If a standard gateway is used, enter the IP address here.
DNS server (menu 7.3.2.5)
If a DNS server is used, enter the server's IP address. For questions regarding the configura-
tion of a DNS server, please contact your network administrator.
Domain (menu 7.3.2.6)
Enter the domain. For questions regarding the configuration of the domain, please contact
your network administrator.
BCOM (menu 7.3.3)
Set the parameters for communication with other devices via BCOM. For further information,
refer to "BCOM" on page 51.
System name (menu 7.3.3.1)
Enter the system name of the network in which the devices are located. In order to guaran-
tee that all devices are able to communicate via BCOM, all devices must have the same sys-
tem name.
Subsystem (menu 7.3.3.2)
Configure the subsystem address of the network in which the devices are located. The
devices can communicate with subsystems with the same or different subsystem addresses.
Device address (menu 7.3.3.3)
Assign a device address. Each device must have a different address to distinguish it from oth-
ers in the system and ensure correct communication.
Timeout (menu 7.3.3.4)
Set the timeout for messages between 100 ms…10 s. This time specification defines the
maximum permissible time for a device to respond.
TTL for subscription (menu 7.3.3.5)
Set a time between 1 s…1092 min. This time determines in what intervals the NGRM7…
sends messages to e.g. a gateway. Severe alarms are always sent immediately.
Modbus TCP (menu 7.3.4)
Settings for communication with other devices via Modbus TCP.
Port 502 (menu 7.3.4.1)
Choose whether Modbus TCP should be used:
on Modbus TCP can be used for communication with other devices.
off Modbus TCP cannot be used for communication with other devices.
To Next Page
Loading...
Need help?
General
