BENDIXKing KSN 8 Series - Pre-Installation Checklist

89000046-014 KSN 780/8XX/900 AeroNav AML STC Installation Manual for Helicopters
Rev 0 Page 2-9
© Honeywell International Inc. Do not copy without express permission of Honeywell.
2.5 Pre-Installation Checklist
Prior to beginning installation of the AeroNav XXX, complete the following pre-installation checklist.
This checklist will help in determining installation requirements. If the Installation Items below are
not complete, additional installation approval may be required.
Installation Item Reference AeroNav
880/900
AeroNav
780/800
Complete
Is the aircraft on the STC Approved Model List? Avidyne Document AVIFD-503
  □
Is AeroNav XXX replacing an existing
GPS/NAV/COM used for Part 91/135 HTAWS
compliance?
If yes, a separate HTAWS
system must be installed.
(Ref. Section 2.1)
 
□
Can the AeroNav XXX helicopter tray be installed
per the data in this manual?
If No, additional installation
approval is required.
 
□
Navigation(s) Antenna Installed
(N/A for AeroNav 880/780)
Section 3.5
 
□
Communication Antenna Installed
(N/A for AeroNav 880/780)
Section 3.4
 
□
Is the AeroNav XXX, or remote annunciator
lights, installed within the Pilot’s Field of View?
Section 5.1 or 5.2
 
□
Does the aircraft have an approved GPS antenna
installed on the aircraft? Or, can the GPS
antenna be installed per this manual?
Section 3.3.5
 
□
Does the aircraft have a sufficient electrical
power for the AeroNav XXX installation?
Section 1.5
 
□
Does the installation location comply with the
Environmental Testing of the AeroNav XXX unit?
Appendix A: Environmental
Qualification Form
 
□
Does the manufacturer’s Airplane Flight Manual
Supplement adequately cover the installation?
If no, additional installation
approval is required.
(Reference: Avidyne
Document 600-00324-000)
 
□
Table 32 Pre-Installation Checklist