89000046-014 KSN 780/8XX/900 AeroNav AML STC Installation Manual for Helicopters
Rev 0 Page 10-6
© Honeywell International Inc. Do not copy without express permission of Honeywell.
10.3 Software Update
The following procedures should be followed when performing optional or mandatory software
change to the AeroNav System:
1. Acquire the software image and associated loading procedure from
the manufacturer.
2. Verify the software part number configuration before and after
maintenance is performed on the airborne equipment using the
loading procedure instructions.
3. It is the responsibility of maintenance personnel to ensure the
identified part is recorded in the necessary maintenance logs.
4. It is the maintenance personnel’s responsibility to ensure that the
software part identification has been logged. When new software is
loaded into the unit, the correct software part number should be
verified according to the instructions accompanying the software
change before the unit is returned to service. Hardware versions are
identified on the data label by brackets following the main part
number.
Changes to software part number, version, and/or operational characteristics should be reflected in
the Operator’s Manual, Aircraft Flight Manual, Aircraft Flight Manual Supplement, and/or any other
appropriate document.
To Next Page
Loading...
