What to do if Altimeter and Airspeed fail on BENDIXKing XVUE TOUCH?
If the BENDIXKing Avionics Display shows 'Altimeter, Airspeed Failures (Red X)', verify the pitot static connections and check for any blockages, water, or debris in the pitot static system. Also, try cycling the power on both the KG 71EXP and KSD 100EXP units. If the issue continues, check the KG 71EXP current draw and wiring, and consider replacing the KG 71EXP.
What to do if attitude fails on BENDIXKing Avionics Display?
If the BENDIXKing Avionics Display shows an Attitude Fail (Red X), wait for the 'Attitude Aligning' message to complete. If you are on the ground, do not move the aircraft during alignment. If in flight, maintain straight and level flight. If the issue persists, try cycling the power on the KG 71EXP and KSD 100EXP. If the problem continues, check the KG 71EXP current draw and wiring, and consider replacing the KG 71EXP.
What to do if heading fails on BENDIXKing XVUE TOUCH?
If the BENDIXKing Avionics Display shows a Heading Fail (Red X), first, allow the 'Attitude Aligning' message to complete. Ensure the aircraft remains stationary on the ground, or maintain straight and level flight if airborne, during alignment. If the issue persists, try cycling power on the KG 71EXP and KSD 100EXP. If there are still problems, complete the Magnetometer Alignment Procedure. Check the wiring from KMG 7010/ MD32 to KG 71EXP and check KMG 7010/MD32 current draw. Consider replacing KMG 7010/MD32. Finally, check the KG 71EXP current draw and wiring, and consider replacing the KG 71EXP.
How to troubleshoot a BENDIXKing XVUE TOUCH Avionics Display that does not power up?
If the BENDIXKing Avionics Display does not power up, check the KSD 100EXP current draw. Inspect the wiring to the KSD 100EXP. Check and/or replace the circuit breaker. If the issue persists, the KSD 100EXP may be defective and require replacement.
What to do if the Smart Touch is not working on BENDIXKing XVUE TOUCH Avionics Display?
If the smart touch feature is not working on your BENDIXKing Avionics Display, try the following: * Reset the KSD 100EXP. * Remove any frost or dust from the IR bar. If the fault persists, replace the KSD 100EXP. If you experience inconsistent or degraded touch response, perform a manual touch calibration.
Why does my BENDIXKing Avionics Display show 'KSD OVERTEMP'?
If the BENDIXKing Avionics Display shows 'KSD OVERTEMP', turn the KSD 100EXP off to allow it to cool down. Check for adequate ventilation and ensure there are no blockages around the KSD 100EXP that could impede airflow.
What causes no navigation data or failure on BENDIXKing Avionics Display?
If you are not receiving navigation data or are experiencing a navigation failure on your BENDIXKing Avionics Display, use a navigation tester to generate a test signal. Ensure the airplane is positioned to receive a navigation signal or GPS satellites. Also, check the wiring from the navigation sensor to the KSD 100EXP. Finally, verify that the configuration is correctly set up for the type of VOR or GPS being used.
Why is OAT data not displayed on my BENDIXKing XVUE TOUCH Avionics Display?
If the Outside Air Temperature (OAT) data is not displayed or is dashed on the BENDIXKing Avionics Display, check the wiring from the KTP 73 to the KG 71EXP. If the wiring is intact, the OAT probe may have failed and require replacement. Also, the KG 71EXP could be defective and require replacement.
Why is there a heading error greater than 4 degrees on my BENDIXKing XVUE TOUCH?
If the heading error is greater than 4 degrees on the BENDIXKing Avionics Display, complete the magnetometer alignment procedure. Check the heading in a clean magnetic location to ensure accuracy. Also, move the aircraft away from any metal structures that may be causing interference.
What to do if PFD data is stale on BENDIXKing XVUE TOUCH Avionics Display?
To resolve stale PFD data on your BENDIXKing Avionics Display, try resetting the KSD 100EXP. If the fault persists, the KSD 100EXP may need to be replaced.
General| Brand | BENDIXKing |
|---|---|
| Model | XVUE TOUCH |
| Category | Avionics Display |
| Language | English |
To Next Page
