89000109-002 xVue Touch Installation Manual
Rev 2 Page 1-3
© Honeywell International Inc. Do not copy without express permission of Honeywell.
For Use in Non-Certified Aircraft
1.3 Acronyms and Abbreviations
(1) The abbreviations are used in agreement with ASME Y14.38.
(2) Acronyms and non-standard abbreviations used in this publication are as follows in Table 1-3.
IEEE 315/ANSI Y32.2 Graphic Symbols for Electrical and Electronics Diagrams (available from the
American National Standards Institute at http://www.ansi.org)
IEEE 802.3 Ethernet Standards
MIL-C-17 Military Specification: Cables, Radio Frequency, Flexible and Semi-rigid
MIL-DTL-5541 Military Specification, Chemical Conversion Coatings on Aluminum and
Aluminum Alloys
MIL-DTL-27500 Detail Specification: Cable, Power, Electrical and Cable Special Purpose,
Electrical Shielded and Unshielded
MIL-HDBK-263 Electrostatic Discharge Control Handbook for Protection of Electrical and
Electronic Parts, Assemblies and Equipment (Excluding Electrically Initiated
Explosive Devices) (Metric) (available from any military standards database)
MIL-STD-1686 Electrostatic Discharge Control Program for Protection of Electrical and
Electronic Parts, Assemblies and Equipment (Excluding Electrically Initiated
Explosive Devices) (Metric) (available from any military standards database).
RS-232/ ANSI TIA-232 Recommended Standard - Serial Interface
RS-422/ ANSI TIA-422 Recommended Standard - Electrical Characteristics of Balanced Voltage
Differential Interface Circuits
Table 1-3 Acronyms and Abbreviations
Acronyms and
Abbreviations
Definition
# Number
AAmp
AC Advisory Circular
A/C Aircraft
ADAHRS Air Data and Attitude Heading Reference System
ADS-B Automatic Dependent Surveillance
AFCS Automatic Flight Control System
AFM Airplane Flight Manual
AHRS Attitude and Heading Reference System
AI Attitude Indicator
ALT Altitude
Table 1-2 Standard References
Document Number Description
To Next Page
Loading...
