BENDIXKing KSN 8 Series - Page 84

89000046-014 KSN 780/8XX/900 AeroNav AML STC Installation Manual for Helicopters
Rev 0 Page 7-5
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Aspen EFD1000 (If connected to an ACU1, set the ARINC 429 speed to
low speed. If connected to an ACU2 and using ADF, RADALT or
Remote OAT data set the ARINC 429 speed to high speed, otherwise
low speed.)
Honeywell Primus 1000
Avidyne EXP5000*
INS/IRU Heading information from the following Inertial systems:
Bendix/King KAH 460
Collins AHC 85
Honeywell Laseref
Litef LTR 81
Litton LTN 90-100, LTN 91, LTN 92
RADAR Graphics Joystick waypoint information from a RADAR graphics unit
Sandel EHSI Selected course and heading information from the following EHSI
systems:
Sandel SN 3308
Sandel SN 3500
Avidyne EXP5000*
Traffic Advisory Traffic information from the following traffic advisory systems:
Bendix/King KTA-870, KMH880
Garmin GTS 800/820/850
Garmin GDL 88
Avidyne TAS6XX (but RS-232 is preferred)
Ryan 9900BX (but RS-232 is preferred)
L3 Communications SKY497 SkyWatch
L3 Communications SKY899 SkyWatch HP
MLB 100 Traffic Avidyne SkyTrax100/MLB100 or Freeflight FDL-978-RX Traffic (But
RS232 is preferred)
Table 78 ARINC 429 Input Selection
*Honeywell EFIS selection is preferred as it has more label information
Note: Only ARINC 429 Traffic is shared between AeroNavs on the CrossSync line, all other ARINC 429
devices should be wired to both AeroNavs in dual AeroNav installations since ARINC 429 data is not
shared between AeroNavs on the CrossSync line.