19 of 109
Quick Needle Threader
The needle thread is used to more easily pass the thread through the eye of
the needle. To use the needle thread, follow the steps below.
1. Lay the top thread across the front of the needle threader and into
the groove. It should lay just across the small metal prong in the
middle of the needle threader.
2. Position the threader above the eye of the needle. Press very gently
in and slide down the thread guide on the needle until the prong
reaches the eye.
3. When the needle thread reaches the eye, the gentle pressure that
you are applying will slide the prong and the thread through the
eye of the needle.
Note: This is difcult with the active needle as the presser foot is close
behind the needle. It may be easier to move the needle case one or
two needles to the left or right before useing the needle threader. Just
remember to move it back before you start sewing again.
4. Carefully remove the needle thread while leaving a loop of thread
through the eye of the needle.
5. Once the needle threader is removed, pull the loop of thread from
the back side of the needle to completely thread the needle.
To Next Page
Loading...