69 of 109
Sewing Caps
Sewing caps will require a little more setup than sewing a at product. For
sewing caps, you will need to do the following.
1. Select the appropriate hoop in software
2. Load the Wide Angle Driver (this may need adjustment the rst time)
3. Hoop a cap - this will change depending on the cap frame. Conventional
Cap Frame (CCF) or Wide Angle Cap Frame (WACF)
4. Load the hooped cap onto the driver
5. Set up the design for caps
6. Load the design and proper settings
7. Adjust the presser foot for the cap
8. Center the design on the cap
The next few sections of this document will assist in sewing a cap.
Select Hoop
In the hoop selection screen, select the hoop you are planning on using.
Selecting the hoop before loading the driver onto the machine isn’t neces-
sary, but it can make the process easier.
Installing & Removing the Wide Angle Driver
Both the cap frames and the micro clamps utilize the Wide Angle Driver.
The Red Wide Angle Driver consists of two pieces:
• The (red) cap frame driver ring
• The lower arm bracket
You must ALWAYS select the proper cap frame hoop in the software
when sewing with cap frames. Failure to do so may result in damage
to your equipment!
To Next Page
Loading...