108 of 109
Maintenance
Maintenance will need to be performed on your machine to keep it running
at an optimal level. Machine maintenance procedures can be found under
the Settings Screen.
The Maintenance Screen will display procedures for the hook, weekly,
monthly, and quarterly maintenance. Each procedure will move the machine
to the appropriate location and walk through all the proper lubrications.
Hook maintenance should be performed every day before sewing and again
after every four hours of solid sewing.
Wide Angle Driver Maintenance
Approximately once per year, the red wide angle driver will need to be
cleaned and greased. The following steps will walk you through the
procedure.
1. Remove the driver cylinder from the machine and lay it upside
down on a at surface.
2. Slide the driver ring fully to one side.
3. Clean the exposed portion of the exposed slider bearing groove
with a clean towel.
To Next Page
Loading...