46 of 109
Adjusting Material Thickness
Adjustments to the material thickness can be made by clicking or tapping
on either the plus or minus button to either side of the material thickness
setting.
Finding just the right settings for your material thickness is not always nec-
essary, but it can make a marked improvement in sew quality and machine
performance.
Sew quality and thread breaks are indicators of appropriate or inappropriate
thread feed. Those symptoms are listed in sections below.
Material Thickness Value is Adequate When...
The material thickness does not need to be adjusted when:
• Satin and ll stitches - There is no looping or pulling on the top of
a sew-out when sewing satin and ll stitches.
• Satin stitches - You can see 1/3 of bobbin showing in the middle of
columns and the top color for the remainder around the sides.
• Fill Stitches - On the back of the sew-out, the top thread is even
along the edge.
To Next Page
Loading...