Bernina E16 - Adding Effects to a Color Block

40 of 109
Adding Effects to a Color Block
Effects can be added to a color block to assist in the embroidering of three
dimensional foam and micro chenille-like effects. These effects will alter the
sew settings only for the color blocks onto which they’ve been applied.
Typically, designs will need to be digitized with specic settings to fully
take advantage of these effects.
3D Foam Effect
Adding 3D Foam effect to a color block will alter the sew settings
for that color block. It will also feed extra thread to better accom-
modate the foam.
To place a 3D Foam effect onto a color block:
1. Locate the color block in the sequence you would like to have the
3D Foam effect.
2. Drag the 3D Foam icon down onto the color block where needed.
3. Release the 3D Foam icon. The effect is now overlaying the color
block.
To remove a 3D Foam effect from the color sequence:
1. Drag the 3D Foam effect off of and away from the color block.
2. Once off of the color block, release the effect to delete it.
Often color blocks with the 3D Foam effect applied are preceded by a
Pause command for the embroiderer to place the dimensional foam. It
is also common to follow the effect with a Pause command to remove
the dimensional foam from the embroidered good.