39 of 109
Pause
A Pause command can be inserted between color blocks in a color
sequence. This will cause the machine to stop and wait to be
restarted, but it will not move the hoop forward.
To place a Pause command into the sequence:
1. Locate when in the sequence you would like the machine to stop.
2. Drag the Pause icon down into the color sequence where needed.
Notice that the color blocks will shift to either side to allow room
for the command.
3. Release the Pause icon. The command is now displayed in the color
sequence.
To remove a Pause command from the color sequence:
1. Drag the Pause command up away from the color sequence.
2. Once off of the sequence, release the command to delete it.
To Next Page
Loading...