9 of 109
Powering Up the Machine
This section will describe how to correctly power up the machine.
Initial Power Up Sequence
1. Make sure that all of the machines are turned off.
2. Make sure the software is launched and the Main Screen is being
displayed.
3. Make sure the E-Stop is disengaged by turning it in the direction of
the arrows.
4. Power up the machine with the power switch.
5. The software will load CSA and RSA les to the machine, and the
machine will initialize and display on screen.
Please note that the rst time the machine is powered up and con-
nected to the software, it may take 90-120 seconds for the machine
to fully initialize and appear on screen. The hoop arms must rst move
from the shipping position to the home position before the machine
can initialize.
To Next Page
Loading...