22 of 109
Inserting the Bobbin Case
CAUTION: Never attempt to remove or insert the bobbin while the
machine is in operation.
1. Insert the bobbin and case in the machine with the pigtail facing
up. Push on the bobbin case until it snaps into place.
2. Test the bobbin orientation by pulling on the thread. The bobbin
should rotate counter-clockwise.
3. Trim the thread to 2 - 3 inches.
NOTE: If the thread is cut too short, it will not pick up on the stitch. If
the thread is left too long, it may wrap into the machine.
To Next Page
Loading...