87 of 109
2. Unlatch the cap frame and swing the frame open and to the right.
Do this by pulling the tab away from the frame. Then, press down
on the edge of the frame to free the latch from the hook. Swing
the frame open.
3. Place an appropriate backing over the gauge and the teeth of the
cap frame. Make sure that the backing is long enough to support
the full embroidery area. It may be easiest to use backing long
enough to reach the teeth on each side of the cap frame.
You may nd it easier to place the backing inside the cap and load
both the backing and the cap onto the frame at the same time. Use
what method works best for you.
To Next Page
Loading...