BEUMER stretch hood® S
Maintenance
BA-6090103-EN
19.08.09
103
Table of lubricants
The lubricants required for the system are listed in the table of lubricants. Fur-
ther information on lubrication and lubrication points is indicated in the operation
instructions of the respective manufacturers. Please note the following legend
for the table of lubrication.
• Qty. = Quantity of same lubrication points in the system
• Description = Description of the lubrication point (the subassemblies marked
with * will be supplied without oil filling)
• DIN (ISO) = Designation of the lubricant type
• ISO / NGLI = Oil viscosity mm2/s at 40 °C
• Fill quantity = Fill quantity per lubrication point (oil in litres, grease in grams).
If there is no entry in the Quantity field, the fill quantity indicated refers to the
corresponding components of the whole system. The individual fill quantity is
indicated on the rating plate.
• First change = in operating hours or years (latest change; pay attention to the
manufacturers' notes!)
• Further changes = in operating hours or years (latest change; pay attention to
the manufacturers' notes!)
Quantity Description DIN (ISO) ISO /
NLGI
Fill quan-
tity
First
change
Further
changes
SEW geared motor CLP (CC) VG 220 4.8 l 3 years 3 years
SEW geared motor CLP (CC) VG 680 9.55 l 3 years 3 years
SEW geared motor CLP PG VG 460 1.2 l 5 years 5 years
Linear guide KP2N-20 2
2,000 h 2,000 h
Chain drives CLP VG 220 Relubrication according to the
operating instructions!
Usable lubricants are indicated in the operating instructions of the respective
manufacturers included in the annex.
To Next Page
Loading...