Beumer stretch hood S - Commissioning Safety and Initial Start-up; Commissioning Safety Instructions; Initial Start-up Requirements

BEUMER stretch hood® S
Commissioning
BA-6090103-EN
19.08.09
45
6 Commissioning
Safety instructions
The machine/system must be operated by trained or instructed personnel only.
Danger!
An unauthorised use of the machine/system could result in severe per-
sonal injury or death and damage to the system.
The machine/system must not be switched on if defects jeopardise the opera-
tional reliability.
First start-up
Basic requirements
Before starting the machine/system, check the following points:
• The installation has been carried out according to the operating instructions.
• There is no foreign matter (tools, auxiliary material etc.) in the system.
• The bearings have been correctly mounted, aligned and filled with lubricant
according to the lubrication list.
• The drive unit (motor, gear unit, coupling, chain drive, belt drive etc.) has
been correctly mounted, aligned and filled with lubricant according to the lu-
brication list.
• The operating voltage corresponds to the voltage indicated on the motor
rating plate.
• The sense of rotation of the individual drive components corresponds to the
conveying direction.
• The intended safety devices have been mounted and are fully functional.
Before start-up, ensure that nobody is endangered by the starting ma-
chine/system.
Warning!
There is risk of injury when the machine/system is switched on while the
protective devices are not mounted.
Operate the machine/system only if all protective and safety devices are in
place and fully functional!