De-commissioning
BEUMER stretch hood® S
106 BA-6090103-EN
19.08.09
Motors and gear units
• Housing parts, toothed gears, shafts as well as anti-friction bearings of gear
units are to be disposed of as steel scrap. This also applies to parts made of
grey cast iron provided they are not collected separately.
• Worm wheels partly consist of non-ferrous metal and are to be disposed of
correspondingly.
• Depending on the material and the relevant regulations, stator, rotor and
terminal box are to be disposed of as steel scrap, electronic scrap, alumin-
ium, copper and plastic.
Before dismounting the drive units, drain off the lubricants and dispose of them
in accordance with the regulations.
Machine actuators
• Sprocket wheels, drive chains, racks, toothed gears and ball-bearing slewing
rings are to be disposed of as steel scrap.
• Depending on the material, toothed belts and conveyor belts are to be dis-
posed of as plastic or rubber.
• Drive pulleys, take-up pulleys and idlers are to be disposed of as steel scrap.
• Pedestal bearings and flanged bearings are to be disposed of as steel scrap.
This also applies to parts made of grey cast iron provided they are not col-
lected separately.
Pneumatic parts
• Depending on the material and the relevant regulations, cylinders, solenoid
valves, bolted joints and compressed-air hoses are to be disposed of as alu-
minium, non-ferrous metal, plastic and electronic scrap.
Electric parts
• Depending on the material and the relevant regulations, the terminal boxes,
proximity switches, photocells, flexible cable ducts and cables are to be dis-
posed of as aluminium, copper, plastic and electronic scrap.
To Next Page
Loading...