To Next PageTo Next PageHow to troubleshoot a Big Joe Forklifts truck when the hydraulic system won't operate?
If the Big Joe forklifts truck and hydraulic system won't operate, start by checking the fuse and replacing it if necessary. Then, inspect the battery quick-disconnect plug and check the battery voltage. If those aren't the issue, bypass the keyswitch to see if it's defective. Finally, check for any open circuits in the wiring and repair as needed.
What to do if Big Joe Forklifts truck does not operate forward or reverse?
If your Big Joe forklift isn't moving forward or reverse, begin by tightening all loose wiring connections. If the problem persists, check the deadman switch and replace it if it's defective. Next, inspect the main contactor for proper operation and replace it if necessary. Finally, check the potentiometer and replace if defective.
Why is there trouble with braking on my Big Joe Forklifts?
If you're experiencing braking issues with your Big Joe forklift, first check the deadman switch for continuity. If there's no continuity when the control arm is in the brake position, replace the switch. If the issue continues, the electric brake may be defective and require replacement.
Lists and explains the key safety features incorporated into the CB33 lift truck design for operator protection.
Outlines crucial safety precautions that must be adhered to at all times when operating the CB33 lift truck.
Details important inspection points and checks to be performed before operating the truck for safety.
Describes the procedures for driving the lift truck forward and in reverse, and various methods for stopping.
Guides troubleshooting for traction and steering controllers, referencing error messages and diagnostic tables.
Details the procedures for removing and installing the steering motor assembly on the lift truck.
Provides step-by-step instructions for replacing the brake assembly on the lift truck.
Provides detailed procedures for replacing lift chains on telescopic and three-stage mast configurations.
Procedures for removing and installing the hydraulic pump and motor assembly, including reservoir service.
Details removal, repair, and installation procedures for telescopic lift cylinders.
Procedures for removing, repairing, and installing free lift cylinders on a three-stage mast.
Steps for removing, repairing, and installing secondary lift cylinders on a three-stage mast.
Procedures for removing, repairing, and installing tilt cylinders on the lift truck.
Covers maintenance, cleaning, removal, disassembly, and installation of the electrical control panel.
Instructions for removing and installing the drive motor, including cleaning recommendations.
General
