BL-CB33-0115 - 03-01-2018 6-1
SECTION 6
BRAKE SERVICING
6-1. BRAKES.
The brake system consists of a drive motor mounted
brake. This brake is spring applied and electrically
released.
6-1.1. Brake Assembly Replacement
1. Block load wheels.
2. Turn off the key switch and disconnect the batter-
ies.
3. Remove the compartment covers as described in
paragraph 5-3.
4. Disconnect electric brake from the harness.
5. Remove three screws and remove brake.
6. Place the new brake into position and secure with
the three screws.
7. Reconnect electric brake to the harness.
8. Install the compartment covers as described in
paragraph 5-3.
9. Reconnect the batteries and turn on the key-
switch.
To Next Page
Loading...
